Inovance SV660FS2R8I-FS - Tuning and Resonance Faults (E661, E662, E663, E664)

Keypad
‑64‑
No. Name
Function
Name
Description
Remarks
31
HomeSwitch Home switch
Disabled ‑ Mechanical
load beyond the home
switch range
Enabled ‑ Mechanical
load within the home
switch range
The corresponding
terminal logic must be
level‑triggered.
34
EmergencyStop
Emergency
stop
Enabled: Position lock
applied after stop at
zero speed
Disabled: Current
operating state
unaffected
The corresponding
terminal logic is
recommended to be level‑
triggered.
38
TouchProbe1
Touch probe
1
Disabled ‑ Touch probe
not triggered
Enabled ‑ Touch probe
triggerable
The touch probe logic is
only related to the touch
probe function (60B8h).
39
TouchProbe2
Touch probe
2
Disabled ‑ Touch probe
not triggered
Enabled ‑ Touch probe
triggerable
The touch probe logic is
only related to the touch
probe function (60B8h).
Description of DO Signals
01 S‑RDY
Servo ready
Enabled ‑ Servo ready
Disabled ‑ Servo not
ready
The servo drive is ready to
run.
02 TGON
Motor
rotation
Disabled ‑ The absolute
value of filtered motor
speed is lower than the
setpoint； H06‑16.
Enabled ‑ The absolute
value of filtered motor
speed reaches the
setpoint of H06‑16.
‑
09 BK
Brake output
Enabled ‑ Brake signal
outputted
Disabled ‑ Brake signal
not outputted
‑
10 WARN
Warning
Enabled ‑ Warning
occurred on the servo
drive
Disabled ‑ No warning
occurred on the servo
drive or the warning
has been reset
‑