Inovance SV660N - Page 26

25
INOVANCE TECHNOLGY EUROPE GmbH
SV660N Startup Procedure_EN_v1.4_20220826.docx
Start
Access to STune
tool
Set the Stune mode
Manual inertia
Enable servo drive
and start moving
the motor
Adjust the stiffness
level during motor
rotating and observe
the waveform during
operation.
The Stune will detect the
mechanical resonance
points and set the notch
filters
Yes
No
End
OK?
Yes
No
Manual Gains tuning
Set H09-00 to 0 to adjust
the gains manually.
Close Stune dialog