25
INOVANCE TECHNOLGY EUROPE GmbH
SV660N Startup Procedure_EN_v1.4_20220826.docx
6.7 CONTINUOS OSCILLOSCOPE
Continuous sampling supports long-term acquisition. During long-term acquisition, the waveform data will be
automatically saved under the current project directory "WaveData". Therefore, if you need to sample
continuously for a long time, you can run for a long time without data loss as long as you ensure enough hard
disk space.
[1] Sample time. Minimum sample time is 3ms
[2]Time Axis
Save sampling data to a file
Auto adjust the data to fit the screen
Active the multi channel mode. If it is active, each channel is shown in a different graph.
Otherwise all channels are shown on the same graph
Enable pan mode. When hold the mouse right cursor over the graph the graph move along
mouse movement
Change to full screen mode
It takes a screenshot of current data sampling
Button to stop sampling. After clicking the data is stored under the current project directory
"WaveData"
Button to pause sampling, and the button becomes .At this time, the data is still being
collected, but the interface data is not refreshed. After clicking the , the sampling resumes,
and the collected data can still be displayed normally during the pause
To Next Page
Loading...
