Insignia Outdoor Series - Step 22: Heater & Guard Installation

www.insigniashowers.com Last Modied: 16/02/2022
24
Step 22 — Installing the heater and heater guard
Locate the heater backplate and screw into posion using the
screws provided in the heater box.
Connect the heater hood by clipping it into the heater. Take
the heater and locate it onto the backplate, resng the boom
within the grooves and securing it in posion with a screw
through a pre-made hole in the hood.
Take the heater guard frame and place it around the heater
and screw into posion using ST60 Screws.