Need help?Do you have a question about the InSinkErator F-201R and is the answer not in the manual?
Lists and illustrates all parts included in the InSinkErator Instant Hot Water Dispenser Filtration System package.
Locate and drill holes for the filter head and bracket, then attach with wood screws.
Cut tubing to length and connect 3/8" tubes to the filter head inlet and outlet sides.
Connect dispenser tubes to the quick-connect fitting and then to the filter head outlet.
Attach a clear tube to the vent hole on the filter head to redirect discharge water.
Connect the water supply line using brass nut, ferrule, and tube insert to the compression fitting.
Turn on cold water, flush the system, and verify all connections are leak-free.
General| Brand | InSinkErator |
|---|---|
| Model | F-201R |
| Type | Water Filtration System |
| Filter Life | 6 months |
| Flow Rate | 0.75 GPM |
| Filtration Method | Carbon Block |
| Stages | 1 |
| Storage Tank Capacity | Not applicable |
| Included Components | Filter cartridge |
| Contaminants Reduced | Chlorine, Sediment |
| Micron Rating | 5 microns |
To Next Page
