STEP 3
A.) Attach the Height Adjustment Handle (#15) to the Left Lock
Switch (#32) on the Pulley Carriage. (Not shown on diagram) And
secure it with one M5 x 10 Allen Bolt (#22). Repeat the same
procedure to install the other side.
B.) Connect the Single Handle (#13) to the Cable (#1) on the Right
Station (#1) with a Spring Clip (#17). Repeat the same procedure
to install the other side.
D.) Lift up the Height Adjustment Handle (#15) and slide the Pulley
Carriage along the Pulley Carriage Support Frame to the selected
level. Release the Handle to lock the Pulley Carriage in position.
E.) Store Curl Bar (#12), and Rope (#11) onto the
Hanger Bracket behind the Upper Cross Brace (#5). Hang Chin Up
Belt (#14) on Upper Cross Brace (#5).
Page 10 05/2020
To Next Page
Loading...
