Getting started with the i90 InstaBox
Installing the battery in the remote
The diagram inside the remote is not very specific. You must install the battery with the positive
(+) side up. Note: The i90 comes with a CR2025, 3-volt Li cell. If you want longer life for your
remote, use a CR2032. The only difference is that the CR2032 is a tiny bit thicker but it still fits
nicely in the remote control. When installing the battery ensure that the positive contact pin is
located next to the rim of the battery and not forced below the disc. See illustration below:
To Next Page
Need help?
General
