Quick-5tart
Guide
ICON IN-WALL ON/OFF SWITCH (#28765)
r
Status
LED""
I
Your new
ICON
On/Off
Switch allows you to control lights and other non-dimma- "X.
ble devices in your home
at
the
touch
of
a button.
INSTEl
Need Help? For assistance call your friendly support
representative
@ 800-SMARTHOME (800-762-7846)
~SETButton
Preparation
Installation should be performed only by a qualified electrician,
or
by
a homeowner who is familiar and comfortable with electrical cir-
cuitry.
If
there are any questions, consult an electrician. For setup questions contact Tech Support
at
Smarthome
for
guidance.
Tools you will need:
• A standard screwdriver.
• A Phillips screwdriver.
• A wire cutter/stripper.
• Optional: A
#1
Phillips screwdriver
"\.0
change the paddle color (sold separately)
• Optional: A voltage tester
to
identify wires inside the junction box
• Optional: A decora wall plate if
you
are replacing a toggle switch
Installing
Your
On/Off
Switch
Step
1.
Two
Signal Extenders (#2842P)
must
be installed if your home does not already have them.
Step
2.
At
the circuit breaker or fuse panel, disconnect the power for all
of
the circuits
in
the switch junction box.
Step
3.
Remove the faceplate from the switch junction box, then unscrew the switch and pull it out from the junction box.
Step
4.
Disconnect the wires from the switch
you
are replacing and ensure
you
have
1/2"
of
bare wire on
the
ends.
Step
5. If you are installing
the
On/Off
Switch into a two-way circuit (where one switch controls the load), follow the diagram
below to identify and connect the
LINE,
LOAD,
NEUTRAL,
and
GROUND
wires. If the colors
of
the wires do
not
match the
diagram,
be
sure
you
have identified the wires correctly before connecting them.
NEUTRAL
Usually White
NOTE
Smarthome Tech Support
800-SMARTHOME
(800-762-7846)
.
The
NEUTRAL
wire will not normally
be connected
to
the
switch you are
replacing.
If
there
is no
NEUTRAL
wire in
the
junction
box, please con-
sult
an electrician
or
call
Non-Dimmable
Load
or
Appliance
LOAD
Usually
Red
or
Blue
LINE
Usually Black
GROUND
Bare
Copper
GROUND
Bare
Copper
•••••••••••
u
-
Main Panel 120VAC
Step
6.
If you are installing into a multi-way circuit (where more than one switch controls the load), consult the User's Guide.
Step
7.
Ensure
that
all wire connectors are firmly attached and
that
there is no exposed copper except for the
GROUND
wire.
Step
8.
Orient the
On/Off
Switch with the status
LED
at
the left, gently place it into the junction box, then screw it into place.
Step
9.
Turn
the circuit breaker back
on
or reinstall the fuse.
Step
10.
Test
that
the
On/Off
Switch is working properly
by
turning the light on and off.
Step
11.
Reinstall the faceplate.
To Next Page
Need help?
General
