InStyler IONIC STYLER PRO - ON;OFF SWITCH WITH 2 HEAT SETTINGS; Heat Settings and Indicator Lights; OPEN;CLOSING THE BARREL; Barrel Mechanism for Styling

For video tips visit YOUTUBE.COM/INSTYLERHAIR
8 9
IONIC STYLER PRO Hot Brush & Ceramic Flat Iron
Slide Down
to Open
Slide Up
to Lock
ON/OFF SWITCH WITH 2 HEAT SETTINGS
Turn the switch on, and select the temperature setting
for your preference.
HIGH Best for normal to thick hair; or hair
that is naturally very wavy or curly.
LOW Best for thin or damaged hair; or hair
that is highly treated or colored.
OFF Turns unit o .
Note: The red indicator light blinks until set
temperature is reached. Start using once the indicator
light stays on.
For safety, turn the ON/OF switch off and
unplug after use.
The red indicator light indicates the InStyler® Ionic
Styler Pro is turned on for either Low or High. The
blinking indicator light indicates the temperature has
not reached the set temperature. If you fi nd the unit
does not turn on, unplug and plug it back in.
OPEN/CLOSING THE BARREL
Open the barrel for straightening, close the barrel to
use as a heated round brush.
To Avoid Tangling
Make sure to brush through the entire head of hair
before styling – Brush through each subsection
individually as many times as necessary until it
e ortlessly passes through the hair.
When styling, make sure to slide through the hair fi rst
prior to rolling: slide fi rst and then roll a little, slide
through again and then roll a little until completely
through the hair section.
When curling, keep the barrel vertical and avoid going
horizontal.
IF YOUR HAIR TANGLES
Follow these steps to detangle your hair:
1. Turn the unit o and unplug it.
2. Do not panic and pull or tug on the tool. That will
only make the tangle worse.
3. Start by unrolling the tool in the opposite
direction that caused the tangle.
4. If unrolling the tool the opposite direction doesn’t
fi x the problem, use a comb to lift and pick out
strands that are snug and tangled. This will create
space and freedom for your hair to become
unwrapped from the tool.
5. Do not attempt to pick the hair out with your
fi ngers or nails between bristles. Use a comb
edge, as the unit is hot.