Intel
®
Desktop Board D865GLC Specification Update
5
• 4 GB maximum total system memory. Refer to Section 2.2.1 on page 59 for
information on the total amount of addressable memory.
• Minimum total system memory: 64 MB
• Non-ECC DIMMs
• Serial Presence Detect
• DDR400, DDR333, and DDR266 SDRAM DIMMs
6. Clarification of Section 2.11.1, DC Loading
Clarification to Section 2.11.1, DC Loading, will be added as follows:
2.11.1 DC LOADING
Table 43 lists the DC loading characteristics of the board. This data is based on a DC
analysis of all active components within the board that impact its power delivery
subsystems. The analysis does not include PCI add-in cards. Minimum values assume
a light load placed on the board that is similar to an environment with no applications
running and no USB current draw. Maximum values assume a load placed on the board
that is similar to a heavy gaming environment with a 500 mA current draw per USB
port. These calculations are not based on specific processor values or memory
configurations but are based on the minimum and maximum current draw possible from
the board’s power delivery subsystems to the processor, memory, and USB ports.
Use the datasheets for add-in cards, such as PCI and AGP, to determine the overall
system power requirements. The selection of a power supply at the system level is
dependent on the system’s usage model and not necessarily tied to a particular
processor speed.
7. Change to Description of Section 2.11.3, Fan Connector Current
Supply, Correction of Processor and Voltage Regulator Fan
Current
Section 2.11.3, Fan Connector Current Supply will change in its entirety as follows:
2.11.3 FAN CONNECTOR CURRENT CAPABILITY
CAUTION
The processor fan must be connected to the processor fan connector, not to a
chassis fan connector. Connecting the processor fan to a chassis fan connector
may result in onboard component damage that will halt fan operation.
To Next Page
Need help?
General
