BIOS
Page 4-10
OnChip IDE Device
Scroll to OnChip IDE Device and press <Enter>. The following screen appears:
IDE HDD Block Mode
IDE Block Mode allows the controller to access blocks of sectors rather than a
single sector at a time. The default is Enabled.
Options: Enabled, Disabled.
On-Chip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two
IDE channels. Select Enabled (default) to activate each channel separately.
Options: Enabled, Disabled.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4)
for each of the four IDE devices that the onboard IDE interface supports. From
Modes 0 to 4 provide successively increased performance. In Auto mode, the
system automatically determines the best mode for each device.
Options: Auto, Mode 0 ~ 4.
IDE Primary/Secondary Master/Slave UDMA
This allows you to select the mode of operation for the IDE drive Ultra DMA-33/
66/100 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver. If your hard drive and your system
[RAID]
To Next Page
Loading...
