Intel Extensible Firmware Interface - Page 426

Extensible Firmware Interface Specification
408 12/12/00 Version 1.02
G.3.4.12 PXE_IFTYPE
The interface type is returned by the Get Initialization Information command and is used by the BC
DHCP protocol function. This field is also used for the low order 8-bits of the H/W type field in
ARP packets. The high order 8-bits of the H/W type field in ARP packets will always be set to
0x00 by the BC.
typedef PXE_UINT8 PXE_IFTYPE;
// This information is from the ARP section of RFC 1700.
// 1 Ethernet (10Mb)
// 2 Experimental Ethernet (3Mb)
// 3 Amateur Radio AX.25
// 4 Proteon ProNET Token Ring
// 5 Chaos
// 6 IEEE 802 Networks
// 7 ARCNET
// 8 Hyperchannel
// 9 Lanstar
// 10 Autonet Short Address
// 11 LocalTalk
// 12 LocalNet (IBM PCNet or SYTEK LocalNET)
// 13 Ultra link
// 14 SMDS
// 15 Frame Relay
// 16 Asynchronous Transmission Mode (ATM)
// 17 HDLC
// 18 Fibre Channel
// 19 Asynchronous Transmission Mode (ATM)
// 20 Serial Line
// 21 Asynchronous Transmission Mode (ATM)
#define PXE_IFTYPE_ETHERNET 0x01
#define PXE_IFTYPE_TOKENRING 0x04
#define PXE_IFTYPE_FIBRE_CHANNEL 0x12