5
PAM-T(AM/FM TUNER MODULE)
4
PAM-T(AM/FM TUNER MODULE)
AM/FM DIGITAL TUNER WITH 30-STATION MEMORY
Easy-to-use, fully digital AM/FM tuner with 30 memory
locations for storing your favorite stations.
MUSIC-ON-HOLD OUTPUT FOR TELEPHONE SYSTEM
Telephone input with Music-on-Hold function for con-
nection with telephone system.
INTEGRATES WITH PAM-SERIES MIXER/AMPLIFIERS
Fits only in left bay of PAM-series Mixers/Amplifiers
Make certain that speakers and input sources are properly
connected before switching on.
Keep volume levels turned down before switching on.
NOTE: The system’s operation is delayed by approximately
three seconds after pressing the power switch. This
is due to the built-in protection circuitry, designed to
protect the speakers and other system components.
12 345
6
AM/FM
MEMO
TUN 1
4
2
5
3
6
UP
DOWN
AM/FM DTS TUNERPAM-T
VOLUME
ON/OFF MAX
AM
FM
MHZ
kHZ
1
1. TUNING FREQUENCY DISPLAY
Displays the current frequency of the tuner.
2
2. BAND SELECTOR
This switch is used to select the AM or FM frequency band.
3
3. ADDRESS SELECT SWITCHES
These switches select between the six memory address
banks used to store radio frequency presets. Each bank
can hold up to five individual presets – three FM (F1, F2,
F3) and two AM (A1, A2), for a total of 30 presets.
4
4. UP AND DOWN SWITCHES
Pressing these switches will move the tuner to the next
active frequency. Holding the switch down for more than
one-half second will activate “Auto-Scan” mode, causing
the tuner to continuously scan, pausing for a few seconds
at each active frequency. Pressing the Up or Down
switch again will de-activate “Auto-Scan” mode.
To Next Page
Loading...
