Changing the configuration parameters on Lismore Legacy Device.
Fourth generation Lismore legacy network devices have the ability to receive configuration data from the Lismore
Network, this is used for example to change the function of an X input or a button etc. We call this data SysX or
System Exclusive messages. The only device capable of sending configuration data is the L7700 IP16 Power
Supply.
1. Ensure the L7700 IP16 Power Supply and system is running normally and you have the devices you wish to
program connected to the output circuit of the L7700 IP16 Power Supply.
2. Ensure you can communicate with the L7700 and view the embedded website.
3. Navigate to the Setup – Commands page and select the Send SysX link on the right hand side of the page.
4. This will bring up the following page:
5. Ensure the equipment you wish to program is connected to the output of the power supply. Enter the numbers
you have been given by the factory and select the Send button at the bottom of the page:
WARNING: ILLEGAL ENTRIES MAY RENDER THE DEVICE INOPERABLE
To Previous Page
Loading...