Reset cameras to factory default
If required, a camera can be reset to the factory default settings.
Reset button
1. Remove the camera cover, press and hold the WPS/RESET
button, and then remove power from the camera.
2. Apply power to the camera and continue holding the
WPS/RESET button for 20 seconds.
Camera configurator
1. Launch the camera configuration browser interface.
2. Select System and then select Maintenance on the left menu.
3. Click Restore or Default to restore the default settings.
Note: After restoring the default settings, the IP address is also
restored to the default IP address.
20 P/N 1073278-EN • REV A • ISS 09MAY17 © 2017 United Technologies Corporation. All rights reserved.
To Next Page
Loading...
