Interlogix TruVision TVB-2403 - Day & Night

12 TruVision HD-TVI 1080P Camera Configuration Manual
MANUAL Adjust the white balance by customizing the Blue and Red value,
which range from 1 to 100.
MANUAL WB
BLUE ---|------
51
RED ---|------ 50
RETURN RET
ATW Select ATW for the white balance to be automatically adjusted
according to the scene illumination.
AWC→SET If enabled, this function will only adjust the WB once. It is best used
in a stable environment.
Day & Night
Select Color, B/W, EXT and AUTO to switch between day and night mode.
Note: AUTO mode of the TVB-X406 camera is the similar to EXT mode of the
other cameras (TVC-2401/4401, TVX-2403/4403, TVB-X404/X405, and TVD-
X404/X405). You can enable/disable IR in EXT mode or TRIGGER mode. The
TVC-X401 camera supports both EXT and AUTO mode; configure the mode in
AUTO mode.
AUTO The image switches from color to B/W or from B/W to color
automatically. The switching threshold value is adjustable.
AUTO mode is supported by the TVC-2401/4401 and TVB-
2406/4406 cameras.
AUTO
1. DELAY -------
|--8 0
2
. D-
>N(AGC
) -------|--8 0
3
. N->D(AGC) -------|--8 0
4. RETURN RET
DELAY: Select the delay before camera switches between Day/Night
mode when the light condition reaches configured threshold. This
function can effectively prevent Day/Night switches caused by
occasional illumination changes.
D->N (AGC): Define the Day/Night switch threshold value from
between 0 and 100.
N->D (AGC): Define the Night/ Day switch threshold value from
between 0 and 100.
COLOR The image is in continuous color day mode.
B/W The image is in continuous black and white night mode. The IR LED
turns on when the lighting conditions are poor.