TruVision HD-TVI 1080P Camera Configuration Manual 15
V-FLIP: Image flips 180 degrees vertically.
ROTATE: Image flips 180 degrees both horizontally and
vertically.
D-ZOOM: Set the digital zoom ON to enlarge the image by creating
pixels through interpolation.
D-ZOOM
1. D-ZOOM x 2.0
2. PAN & TILT
3. DEFAULT
4. RETURN RET
D-ZOOM: Set the zoom factor between 2 and 62.
PAN & TILT: Define zoom area in PAN & TILT menus.
DEFAULT: Set to restore D-ZOOM back to the default settings.
SMART D-ZOOM: When the feature is enabled, the image of the
detected moving object in the pre-defined area will be enlarged. The
D-Zoom area, sensitivity, and zoom factor are configurable.
SMART D
-
ZOOM
1
.
SELECT AREA1
2.
DISPLAY ON
3. SENSITIVITY ---
|----31
4
.
D-ZOOM x
2.0
5
.TIME --
|-------3
6
.DEFAULT
7.
RETURN RET
Note: D-Zoom and Smart D-Zoom cannot take effect
simultaneously.
Up to two areas can be set in one camera. Move the cursor
up/down to select the area.
NEG. IMAGE: Negative image. Select ON to reverse bright and dark
areas of the image.
Note: When WDR is enabled, D-Zoom and Smart D Zoom cannot be
configured.
MOTION Define the settings to detect movement and trigger an alarm.
SELECT: Select the MOTION area number.
DISPLAY: Set ON to enter to define the position and size of the
motion detection area.
SENSITIVITY: Set the value according to the situation. The range is
To Next Page
Loading...
