Intermatic RC613L - Operation; Linking an RC939 Transmitter; Linking Multiple Transmitters; Excluding a Transmitter Link

OPERATION
Linking an RC939 Transmitter Button with the RC613 Receiver
NOTE: The transmitter must be within 6 feet of the receiver during setup.
1. On the remote (RC939), use a paper clip to press and release the button on the lower right-hand side. The
red LED on the remote should be solid red now.
2. On the receiver (RC613), press and hold the blue CODE SET button for 3 seconds.
3. Now, with one-second intervals, tap the button that you want to program on the remote repeatedly until you
hear the relay click inside the receiver. (Press at least 7 times)
4. Now press a different button on the remote to save your setting. (Red LED should go out)
5. Test the button you just programmed. If it is not working, make sure the red LED on the remote is off and go
back to step 1.
NOTE: To clear any existing codes, press and hold the blue CODE SET button on the receiver for 20 seconds,
then release. (This will eliminate all stored codes)
Linking Multiple Transmitters with a Receiver
Up to three different transmitters can control a receiver. Follow steps 1 through 5 above for linking each RC939
transmitter with the RC613 receiver.
Excluding a Transmitter Button Link from a Receiver
Follow this procedure to exclude a transmitter button from a receiver:
1. With a paper clip, press the button on the side of the transmitter until the red LED illuminates.
2. Momentarily press the congured ON/OFF button on the transmitter that you want to exclude from the receiver.
3. Momentarily press one of the other buttons on the transmitter. The red LED on the transmitter turns OFF.
4. Momentarily press the button you wanted to exclude to verify it no longer controls the receiver. The button
is now excluded.
3
LIST OF AVAILABLE MODELS AND COMPONENTS
Model Description Ratings (60 Hz)
RC613 Single-Channel Receiver 15 A Resistive, 10 A (1200 W) Tungsten, 1 HP (16 A FLA) @ 120 VAC, Single-Pole Single-
Throw Contacts
RC613L Single-Channel Receiver
with 36 in. Lead
15 A Resistive, 10 A (1200 W) Tungsten, 1 HP (16 A FLA) @ 120 VAC, Single-Pole Single-
Throw Contacts
RC613R Heavy-Duty Single-Channel
Receiver and Relay Assembly
20 A Resistive @ 120/240 VAC. 12.5 A (1500 W) Tungsten, 1 1/2 HP @ 120 VAC; 3 HP @
240 VAC, Double-Pole Single-Throw Contacts
RC939 3-Channel Transmitter with
replaceable CR2032 Lithium
Battery