Intermec TRAKKER Antares 2420 - Page 373

Co de 39
Nugget
Configuration Command Reference
9-105
9
2. Scan the serial port from these bar codes:
COM1 COM3
*1.* *3.*
*1.* *3.*
COM4
*4.*
*4.*
3. Scan a bar code for
data
from the “Full ASCII Bar Code Chart” in Appendix B.
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set SOM for another serial port.
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
PE
data
where
data
is an ASCII character.