Intermec TRAKKER Antares 2420 - Page 385

Co de 39
Nugget
Configuration Command Reference
9-117
9
Or: To set the timeout delay for one serial port:
1. Scan this bar code:
Enter Accumulate Mode / Set Timeout Delay
*+/$+YE*
*+/$+YE*
2. Scan the serial port from these bar codes:
COM1 COM3
*1.* *3.*
*1.* *3.*
COM4
*4.*
*4.*
3. Scan the timeout delay from these bar codes:
Timeout Delay 5 ms Timeout Delay 100 ms
*0* *1*
*0* *1*
Timeout Delay 500 ms Timeout Delay 2 sec
*2* *3*
*2* *3*
Timeout Delay 10 sec Timeout Delay 20 sec
*4* *5*
*4* *5*
Timeout Delay 40 sec Timeout Delay 60 sec
*6* *7*
*6* *7*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the timeout delay for another serial port.