International Biomedical AirBORNE A750i User Manual

112 pages

To Next Page

A750i Transport Incubator

Service Manual

Table of Contents3
Language Disclaimer6
Section 1: General Information13
Introduction13
Classification13
Safety Summary14
Important Safety Considerations14
Symbols20
Section 2: Set-Up Instructions21
MODEL A750I UNPACKING and ASSEMBLY21
Assembly of the Airway Management System (Optional)25
INSTALLATION of the MVP-10 or CROSSVENT 2I VENTILATOR (OPTIONAL)26
Installation of the Suction Unit (Optional)28
Air and Oxygen Tanks29
Operational Check29
Section 3: Operating Instructions30
Front Panel Display Features30
Side Panel Features35
Power Features36
Powering up the Incubator38
Powering off the Incubator38
Display Modes39
Temperature Control39
Setting the Infant Chamber Air Temperature39
Pulse Oximeter and Oxygen Monitor Control (Optional Feature)40
Alarms / Indicators40
External Lighting43
Skin Temperature Probe43
Section 4: Pulse Oximetry (Optional Feature)44
Pulse Oximeter Principles of Operation44
Pulse Oximeter Set-Up Instructions46
Initial Set-Up46
SETTING HIGH and LOW %Spo 2 ALARMS46
Setting High and Low Pulse Rate Alarms47
Setting the Algorithm Mode (Masimo Only)47
Setting the Averaging Mode (Masimo Only)48
Setting the Perfusion Index (Masimo Only)49
Operational Alarms and Warnings49
Test of Operational Alarms51
Pulse Oximetry Sensors51
Pulse Oximetry Testers / Simulators52
Section 5: Oxygen Monitor (Optional Feature)53
Oxygen Monitor Principles of Operation53
Oxygen Monitor Set-Up Instructions54
Initial Set-Up54
Setting High and Low Oxygen Alarms54
Oxygen Monitor Calibration55
Operational Alarms and Warnings56
Test of Operational Alarms56
Oxygen Sensor57
Section 6: Preventative Maintenance58
Daily Maintenance58
Operational Check58
Air / Oxygen System59
Infant Chamber Check60
Cart and Accessories60
Sensors and Cables (Optional Equipment)60
Cleaning of Incubator and Chamber61
Cleaning of Cables (Optional Equipment)61
Cleaning of Pulse Oximetry Sensor (Optional Equipment)61
Cleaning of Oxygen Sensor (Optional Equipment)61
Monthly Maintenance62
Operational Check62
Keyboard / Led Check (Optional Feature)62
Alarm Mute Check (Optional Feature)62
Tank Inspection62
Infant Chamber Inspection & Cleaning63
Battery Test63
Air Flow System Inspection & Cleaning64
Hardware64
Battery Care65
Product Disposal / Recycling65
Section 7: Troubleshooting66
General Troubleshooting66
Main Display Error Codes67
Pulse Oximeter and Oxygen Monitor Failure Codes (Optional Feature)67
Section 8: Internal Component Access70
Electronics Compartment Access70
Battery Removal71
Control Board Removal71
Display Board Removal72
Pulseox Display Board Removal72
Pulse Oximeter Board Removal73
Section 9: Calibration Procedures74
Calibration Test Equipment Required74
System Calibration Procedure74
Control Board Calibration Procedure77
Display Board Calibration Procedure80
Section 10: Circuit Description81
Control Board81
Temperature Regulation81
Failsafe Temperature Limit82
Alarms82
Power Fail Alarm83
Voltage Reference83
Lamp Drive Circuit83
Battery Charger84
Power Source Selection85
Display Board85
Measured Temperature Display85
Main Incubator Alarm and Power Indicators86
Temperature Setpoint86
Setpoint Alarm86
PULSE, Spo 2 , and OXYGEN DISPLAYS (OPTIONAL FEATURES)86
Saturation, Pulse, Oxygen, and Pulse Graph Displays (Optional Features)87
Alarm and Power Indicators (Optional Features)87
Alarm Setpoints (Optional Feature)87
Setpoint Alarm (Optional Feature)87
Other Alarm and Warning Conditions87
General Mechanical Specifications88
Section 11: Specifications89
Electrical Specifications89
Operational Specifications89
Emc Specifications89
Essential Performance93
Pulse Oximeter Specifications (Optional Feature)94
Oxygen Monitor Specifications (Optional Feature)96
Operating, Storage, and Transport Environment97
Section 12: Warranty98
Section 13: System Documentation99
European Regulatory Affairs Representative99
Parts and Accessories99
Section 14: Schematics / Drawings100
System Wiring Diagram, Masimo Pulseox (002-0011)100
System Wiring Diagram, Nellcor Pulseox (002-0014)101
Control Board Schematic (001-5181)102
Pulseox Display Board Schematic (001-5193)103
Schematic, Non-Pulseox Display Board (001-5192)109
Temperature Sensor Resistance Values111
SCHEMATIC, PNEUMATIC A750I CART (002-4010)112

Need help?

Do you have a question about the International Biomedical AirBORNE A750i and is the answer not in the manual?

International Biomedical AirBORNE A750i Specifications

General

Brand	International Biomedical
Model	AirBORNE A750i
Category	Accessories
Language	English

Related product manuals

Airborne Voyager

108 pages

AirBorne NxtGen Transport Incubator

150 pages

International Biomedical AirBORNE A750i User Manual

Table of Contents

International Biomedical AirBORNE A750i Specifications

Related product manuals