347
PO
S AVE THESE INSTRUCTIONS
(347PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/11/2019
English
Page 10
SET UP (continued)
6.
Replace the air valve cap back.
The cap is designed to be screwed on and off. Never exert force
as this could cause the complete internal infl ation system of the
valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
NOTE:
If there is a need to replace the spa tub air pressure release
valve core
(23)
due to wear and tear, use the included wrench
(22)
to unscrew the core from the valve base. Replace a new air pressure
release valve core back. Make sure the core is securely tightened
(see drawing 6)
.
Infl ate the Spa Cover Air Bladder
1.
Open the infl ation valve and insert the infl ation hose
(7)
into the
valve; press
to infl ate until it is fi rm to the touch but not hard
(see drawing 7)
.
2.
Disconnect the infl ation hose
(7)
from the air blower infl ation outlet
and the valve.
3.
Replace the control base infl ation latch back; close and recess
the infl ation valve.
NOTE:
If there is a need to add some air to the spa tub wall or spa
cover air bladder after they have been setup, refer to above “Infl ate
the Spa Tub Wall” and “Infl ate the Spa Cover Air Bladder” sections.
The cover air bladder is preinstalled inside the spa cover. If it needs to
be reinstalled, place the uninfl ated air bladder inside the spa cover lip before infl ating the bladder.
5
IMPORTANT:
To prevent damage to the air blower motor never
block the air blower outlet opening during infl ation.
7
7
6
22
23
5.
Press the
button again to turn it off.
To Next Page
Loading...
Need help?
General
