Need help?Do you have a question about the Intrepid Control Systems neoVI FIRE 2 and is the answer not in the manual?
Step-by-step guide for installing Vehicle Spy software and necessary drivers.
Instructions for installing drivers and API support files without Vehicle Spy.
Illustrates how to physically connect the neoVI FIRE 2 to vehicle networks and PC.
Details on connecting the device to vehicle networks and power sources.
Guide on connecting the neoVI FIRE 2 to a computer via USB.
Guide to using the neoVI Explorer utility for device management and configuration.
Covers system-wide settings and procedures for updating device firmware.
Configuration of standard dual wire CAN networks.
Configuration of user-selectable CAN channels (HS, LSFT, SW CAN).
Demonstrates how to monitor CAN/LIN traffic using Vehicle Spy.
Shows how to create and transmit custom CAN messages.
Guide for connecting to Automotive Ethernet networks via RAD-Moon.
General| CAN FD Bitrate | Up to 8 Mbps |
|---|---|
| LIN Bitrate | Up to 20 kbps |
| Operating Temperature | -40°C to +85°C |
| Device Type | Vehicle Network Interface |
| Connectivity | USB, Ethernet |
| Interfaces | CAN, CAN FD, LIN, Ethernet, FlexRay |
| Supported Protocols | CAN, CAN FD, LIN, FlexRay, Ethernet |
| FlexRay | Up to 10 Mbps |
To Next Page