Assemble
Raise up the rear ap (4), hang the collection bag on the hooks.
4. Connection to the power supply
a. Connect the plug to the extension cord.
About 30 cm from the end, creade a loop in the cable. Guide the loop through the oval
hole of the cable strain relief, and over the hook. Carefully pull it tight.
b. Connect the plug of extension cord to the power supply.
WARNING! Check the voltage and current! The voltage
and current must comply with the information on the rating
label. Always use a power supply protected by a residual-
current-operated protective device RCD). If using an extension
cord, ensure it is of the proper size and type for your product
(≥1.5mm2). Use an extension cord specically designed for
outdoor use.
63
To Next Page
Loading...
