PLUS (+) AND MINUS (-) CONTROL BUTTONS
Humidity Set Control Button
Press the relative buttons (PLUS or MINUS) to set your desired humidity level within a
range of 35% RH (Relative Humidity) to 85% RH (Relative Humidity) in 5% increments,
each time one of the relative buttons are pressed.
• For drier air press the “Minus” (-) button to set a lower percent value (%).
• For damper air, press the “Plus” (+) button to set a higher percent value (%).
TIMER
Press the “TIMER” button to initiate the auto START or auto STOP function in
combination with the PLUS (+) and MINUS (-) buttons. The “TIMER” indicator and the
Display will turn on.
• When unit is on, press the Timer button to activate the auto STOP function.
When the unit is o, press this button to activate the auto START function.
• Press the (+) or (-) button to change the time by 0.5 hour increments, up
to 10 hours or by 1 hour increments up to 24 hours. The control panel will
then count down time remaining until START or STOP.
• The time selected will be stored within 5 seconds and the main display
will automatically return to its previous state.
• When the auto START or auto STOP functions is set the Timer indicator is
lit identifying that ON or OFF timers are programmed.
• Turning the unit ON or OFF at any time or changing the timers setting to
0.0 will terminate the Auto Start/Stop function.
• When the control panel window displays code “P2”, the Auto Start/Stop
function will be terminated.
SILENT
Press the “SILENT” button (the indicator will turn on) to activate low fan speed. By
pressing the “SILENT” button once again (the indicator will turn o) setting the unit
back to normal fan speed.
• When the set humidity has been reached and if quiet operation is preferable,
set fan control to low.
To Next Page
Loading...
Need help?
General
