INVT Goodrive 200 - Page 101

Goodrive200 inverters Function codes
100
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
frequency is off
0:Save when the power is off
1:Clear when the power is off
LED tens:The action s
election when the other
frequency set frequency is off
0:Save when the power is off
1:Clear when the power is off
P08.48
High bit of
initial power
consumption
0° ○
P08.49
Low bit of
initial power
consumption
This parameter is used to set the initial
value of the
power comsumotion.
The original value of the power consumption
=P08.48*1000+ P08.49
Setting range of P08.48: 0~59999°(k)
Setting range of P08.49:0.0~999.9°
0.0° ○
P08.50
Magnetic flux
braking
This function code is used to enable magnetic flux.
0: Invalid.
This inverter can slow down the motor by increasing
the magnetic flux. The energy generated by th
e
motor during braking can be transformed
into heat
energy by increasing the magnetic flux.
T
he inverter monitors the state of the motor
continuously
even during the magnetic flux period.
S
o the magnetic flux can be used in the motor stop,
as well as to c
hange the rotation speed of the motor.
Its other advantages are:
Brake immediately after the stop command. It does
not need to wait the magnetic flux weaken.
The cooling is better. T
he current of the stator other
than the rotor increases during magnetic
flux
braking, while the cooling of the stator is more
effective than the rotor.
0 ●
P08.51
Input power This function
code is used to adjust the displayed
0.56 ○