INVT Goodrive 200 - Page 74

Goodrive200 inverters Function codes
73
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
and the direction is controlled by REV. Sin
is
natural closed.
3:3-wire control 2; Sin
is the enabling terminal on this
mode, and the running command is caused by SB1
or SB3
and both of them control the running
direction.NC SB2 generates the stop command.
Note: for the 2-wire running mode, when FWD/REV
terminal is effective, the inverter stop because of the
stopping command from other sources
, even the
control terminal FWD/REV keeps effective;
the
inverter won’t work when the stopping
command is
canceled. Only when FWD/REV
is relaunched, the
inverter can start again. F
or example, the effective
STOP/RSTstop when PLC signal cycles stop
,
fixed-length stop and terminal control (see P07.04).
P05.14
S1 terminal
switching-
on
delay time
0.000s
○
P05.15
S1
T
he function code defines the corresponding delay
time of electrical level of the programmable terminals
from switching on to switching off.
0.000s
○