INVT Goodrive 200 - Page 84

Goodrive200 inverters Function codes
83
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
parameter menu. O
nly correct password can make
the user check or modify the parameters. P
lease
remember all users’ passwords.
Retreat editing
state of the function codes and the
password protection will become valid in 1 minute. I
f
the password is available, press PRG/ESCto enter
into the editing
state of the function codes, and then
“0.0.0.0.0” will be displayed. U
nless input right
password, the operator can not enter into it.
Note: restoring to the default
value can clear the
password, please use it with caution.
P07.01
Parameter
copy
The function code determines the mode
of
parameters copy.
0:No operation
1:Upload the local function parameter to the keypad
2:Download
the keypad function parameter to local
address(including the motor parameters)
3:Download t
he keypad function parameter to local
address (excluding the motor parameter of P02, P12
group)
4:
Download the keypad function parameters to local
address (only for the motor parameter of P02,P12
group)
Note: After completing the 1~4 operation,
the
parameter will come back to 0 automatically,
the
function
of upload and download excludes the
factory parameters of P29.
0 ◎
P07.02
QUICK/JOG
function
selection
0:No function
1: Jogging. Press QUICK/JOG to begin the jogging
running.
2: Shift the display state by the shifting key. Press
1 ◎