INVT Goodrive 200 - Page 85

Goodrive200 inverters Function codes
84
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
QUICK/JOG
to shift the displayed function code from
right to left.
3: Shift between forward rotations
and reverse
rotations. P
ress QUICK/JOG to shift the direction of
the frequency commands. This function
is only valid
in the keypad commands channels.
4: Clear UP/DOWN settings. Press QUICK/JOG to
clear the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to stop.
6: Shift the running commands source. P
ress
QUICK/JOG to shift the running commands source.
7:Quick commission mode(committee according to
the non-factory parameter)
Note: Press QUICK/JOG
to shift between forward
rotation
and reverse rotation, the inverter does not
record the state after shifting during
powering off.
The inverter will run according to parameter P00.
13
during next powering on.
P07.03
QUICK/JOG
the shifting
sequence of
running
command
channel
When
P07.06=6, set the shifting sequence of
running command channels.
0:Keypad control→
terminals control
→communication control
1:Keypad control←→terminals control
2:Keypad control←→communication control
3:Terminals control←→communication control
0 ○
P07.04
STOP/RST
stop function
Select the stop function by STOP/RST. STOP/RST
is effective in any state for the fault reset.
0:Only valid for the panel control
1:Both valid for panel and terminals control
2:Both valid for panel and communication control
3:Valid for all control modes
0 ○