INVT Goodrive 35 Series - Page 99

Goodrive35 inverters Function codes
98
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
37~40: Reserved
P06.05
Polarity of
output
terminals
The function code is used to set the pole of the
output terminal.
When the current bit is set to 0, input terminal is
positive.
When the current bit is set to 1, input terminal is
negative.
BIT0
BIT1
BIT2
BIT3
Y1
HDO
RO1
RO2
Setting range: 0x0~0xF
0x0
○
P06.06
Y1
switch-on
delay time
The function code defines the corresponding delay
time of the electrical level change during the
programmable terminal switching on and off.
The setting range :0.000~50.000s
Note: P06.08 and P06.08 are valid only when
P06.00=1.
0.000s
○
P06.07
Y1
switch-off
delay time
0.000s
○
P06.08
HDO
switch-on
delay time
0.000s
○
P06.09
HDO
switch-off
delay time
0.000s
○
P06.10
RO1
switch-on
delay time
0.000s
○
P06.11
RO1
switch-off
delay time
0.000s
○
P06.12
RO2
switch-on
0.000s
○
www.barghmaher.ir