IPCamPower IPCP-4P2G-AF2 - User Manual

USER GUIDE
PoE Switch
PoE & Optical Transmission
Statement
1 PoE switch
1 Power Cord / Adapter
1 Mounting Kits
1 User Guide
Copyright © 2018 IPCamPower.com
This document contains proprietary information that is protected by copyright. No part of this document may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, in any form
or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise without the prior written
permission of Our company.
The information and product specifications within this document are subject to change at any time, without notice
and without obligation to notify any person of such change.
Packing List
Product overview
Product Introduction
IPCP-4P2G-AF2 PoE Switch was designed specifically for IP cameras that utilize the standard PoE power type of
802.3af. This is a great PoE switch for systems utilizing 4 cameras or less. However, this PoE switch can be used to
power any type of device that uses standard PoE power such as IP phones, Wireless access points, and other
devices that use the 802.3af/at standard.
Feature
Complies to IEEE802.3af/at standards.
4 10/100 PoE powered Ports with 2 additional 10/100 non-powered uplink ports.
All the ports support Auto MDI/MDIX.
Each PoE port support Power up to 30 Watts with a total budget of 65 Watts for the entire switch
Support IEEE802.3x Full Duplex flow control and Duplex back pressure flow control function
Automatic MAC address learning and updating.
4K MAC Address
16G Broadband and 192Kb forwarding memory.
High performance full load power configuration.
LED indicator monitor working status and help fault detection
Technical Structure and Port Description
3 4 5 6
LIN K
PoE
LIN K
SPD
1 2
10/ 100M Po E Switc h
PWR
118mm
25mm
89mm
POWER
A
B
C
3 4 5 6
LIN K
PoE
LIN K
SPD
1 2
10/ 100M Po E Switc h
PWR
A.PoE port B.Uplink C. DC 48-52V

IPCamPower IPCP-4P2G-AF2 Specifications