Better Packages Inc. 5
5
To Set for Two Rolls
1. Lift forward end of tape divider plate from slot and the rear portion of the dispenser and place in
the desired slots that correspond with the width of your two rolls of tape. Combination of widths:
2”, 1 ½” and 1” (see figure 5).
Figure #5
To Operate
1. Press tape against back of bridge plate and feed a short piece (see figure 6).
2. Pull tape out in a slightly downward direction to insure thorough moistening (see figure 7).
3. Draw out tape and tear off desired length (see figure8).
Figure #6 Figure #7 Figure #8
Suggestions for Maintenance
1. Keep the tank two thirds full for best moistening. Check water level to insure satisfactory
moistening of tape.
2. Clean brush with soap and rinse once a week to eliminate adhesive build-up.
3. Remove cutting knife and bridge plate monthly for cleaning.
4. Periodically lubricate rolling bearing with a drop of light oil to insure smooth and efficient
operation.
5. The tank is easily removed for cleaning. Unsnap the bridge plate and cutter knife at sides and
remove; then lift off tank. To re-assemble hook tank into position and snap on bridge plate with
the serrated cutting lip towards the front of the machine (see figure 9, 10, 11).
Figure #9 Figure #10 Figure #11
Thank you for Choosing Better Packages.
To Next Page
Loading...