Number of Beeps - Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of
beeps will be applied to the beeper and LED in response to a good read. For example, if
change the number of beeps, scan the barcode
below and then scan a digit (1-9)
barcode and the Save barcode on the Programming Chart at the end of this chapter.
Default = 1.
Number of Beeps - Error
change the number of error beeps, scan the barcode below and then scan a digit (1-9)
barcode and the Save barcode on the Programming Chart at the end of this chapter. De -
fault = 1.
25
To Next Page
Loading...