1. Position the metal latch plates (E) on left side of doorway in Panel (A), lining
them up with the screw holes in the doorway; Place 1 metal latch catch (F) on
top of each latch plate (E) so that the screw holes line up; Secure each latch
plate (E) and latch catch (F) together to the doorway using 2 Phillips screws (G)
for each set.
(Note: Make sure that the opening of each latch catch is facing upwards.)
2. Attach both latches (D) to the left side of the door using 2 Phillips screws (G)
for each set.
3. Attach hinges (C) to the right side of the door using 2 Phillips screws (G) for
each hinge, lining up the holes in the hinge with the screw holes in the side of
the door.
(Note: Check that the hinges open correctly and are not reversed.)
4. Attach the door to the right side of the doorway using 2 Phillips screws (G)
for each hinge.
5. Check the fit and function of the door and the latches, then make sure all
the screws are tight.
6. Insert 2 rubber feet {I) into holes in the bottom of each panel.
7. Connect 2 panels together by lining them up at the corners, then
insert a metal connecting rod (J) into each corner from the top; Repeat until all
panels are connected.
1. This pen is for pet use only; Do not allow children to play in or around it;
2. Do not climb on the pen, lean on it or put excessive weight on it;
3. Make sure the pen is always placed on a flat surface;
4. Make sure the door is properly locked when pets are inside; Periodically
check on your pets;
5. Do not place the pen near a fireplace or other source of heat;
6. Wash with mild soap and warm water; Rinse with a damp cloth or sponge.
To Previous Page
Loading...