13423 W. Cactus Road
Surprise, AZ 85379 USA
www.irisusainc.com
1. Position the metal latch plates (E) on left side of doorway in Panel (A), lining
them up with the screw holes in the doorway; Place 1 metal latch catch (F) on
top of each latch plate (E) so that the screw holes line up; Secure each latch
plate (E) and latch catch (F) together to the doorway using 2 round-head screws
(H) for each set.
(Note: Make sure that the opening of each latch catch is facing upwards.)
2. Attach both latches (D) to the left side of the door using 2 round-head
screws (H) for each set.
3. Attach hinges (C) to the right side of the door using 2 flat-head screws (G)
for each hinge, lining up the holes in the hinge with the screw holes in the side
of the door.
(Note: Check that the hinges open correctly and are not reversed.)
4. Attach the door to the right side of the doorway using 2 flat-head screws
(G) for each hinge.
5. Check the fit and function of the door and the latches, then make sure all
the screws are tight.
Insert 2 rubber feet {I) into
holes in the bottom of each panel.
1. This pen is for pet use only; Do not allow children to play in or around it;
2. Do not climb on the pen, lean on it or put excessive weight on it;
3. Make sure the pen is always placed on a flat surface;
4. Make sure the door is properly locked when pets are inside; Periodically
check on your pets;
5. Do not place the pen near a fireplace or other source of heat;
6. Wash with mild soap and warm water; Rinse with a damp cloth or sponge.
To Previous Page
Loading...
