9
Status LED: Brightens gradually, dims suddenly.
Description Access Point (AP) Mode
Beeper None
Reset Button Effect A reset will cause the controller to re-scan the WiFi networks.
To reset the controller, press the reset button 8 times with a paper clip (about once per
second) until the controller beeps.
Notes / Remedy This state occurs when a new controller is powered up. It will also occur after the wireless
controller has been reset. In this mode, the wireless controller will operate as an access
point to connect to a WiFi local network. See Note 2 at the end of the troubleshooting
section.
Status LED: Steady on, brightens briefl y when posting.
Description Connected & Posting
Beeper None
Button Press Effect To change the controller’s state to Access Point (AP) mode, press the reset button 8 times
with a paper clip (about once per second) until the controller beeps.
To restart the controller, press and hold the reset button down until you hear a beep (about
12 seconds), then release. The controller will reconnect to web server.
Notes / Remedy Normal Operation
Continued on the next page.
Status LED Flash Codes (Continued)
To Next Page
Loading...