IRISPen Executive 7 - Scanning Vertical and Table Data

English English
Tip: to hear the text read out loud after scanning, select the Say out loud option
on the ribbon.
Note:
By default, IRISPen
TM
adds a space after each scan, and adds new scans on the same line
in your application until the line is full.
To start a scan on a new line:
• Click and slide the IRISPen
TM
over a line of text.
• At the end of the line, click again with the IRISPen
TM
.
The cursor now moves to the line below. To modify the default settings, see the topic
Configuration
.
5.1.1 Scanning Vertical Text
IRISPen
TM
Executive 7 can scan vertical text, to scan Japanese text for instance.
To scan vertical Japanese text:
1. Select Japanese from the language list.
2. Then select Vertical on the ribbon.
5.1.2 Scanning Tables
IRISPen
TM
Executive 7 can scan tables to spreadsheet applications such as Excel:
1. Select Table mode > ON.
2. Open a spreadsheet application and mouse click inside it.
3. Click and slide the IRISPen
TM
over a table line.
The content is filled in in different cells in the application.
5.1.3 Scanning Numbers
When your documents contain numbers only, it recommended activating the numbers
only feature:
1. Select Scan text as > 123... on the tab Scan to doc / app.
5.1.4 Scanning Single Words
To scan single words, instead of full lines:
1. Select Text span > Single word.
2. Place the scanner well in front of each word to start the scanning, and also end
the scanning well after each word.
6