iRobot Roomba Combo j5 User Manual

Regulatory Information
FCC Supplier's Declaration of Conformity
iRobot Corporation Roomba Model: RVE-Yl, ADG-Nl
Contains FCC ID: UFE-AXGYl and contains IC: 6652A-AXGY1
This device complies with part 15 of the FCC Rules and CAN ICES-003(8) /
NMB-003(8).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(l) This device may not cause interference, and
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
Changes or modifications not expressly approved by iRobot Corporation
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules as well as
CAN ICES-003(8) / NMB-003(8) Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference to radio communication
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than the necessary for successful communication.
• FCC Radiation Exposure Statement: This product complies with
FCC §2. l 091 (b) for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as
described in this manual. Per FCC requirements, maintain a distance
of more than 8 inches (20 cm) between any person and the host device
(Roomba robot).
• ISED Radiation Exposure Statement: This product complies with the
Canadian Standard RSS-102 for mobile device RF exposure limits, set forth
for an uncontrolled environment and is safe for the intended operation as
described in this manual. Per ISED requirements, maintain a distance of
more than 8 inches (20 cm) between any person and the robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.
http://global.irobot.com
For battery recycling go to call2recycle.org;
or call l-800-822-8837
Roomba™ jS+ Safety Guide 5
E

iRobot Roomba Combo j5 Specifications

General

Shape	Round
Product color	Anthracite
Dust container type	Combi
Smartphone remote support	Yes
Package type	Box
Package depth	535 mm
Package width	141 mm
Package height	414 mm
Package weight	6020 g
Water tank capacity	210 L
Dust capacity (total)	276 L
HEPA filtration system	-
Battery capacity	2210 mAh

Weight and Dimensions

Depth	339 mm
Width	338 mm
Height	87 mm
Weight	3400 g