EN
Roomba™ j9+ Owner’s Guide 9
Note: To achieve optimal
performance with your robot
and automatic dirt disposal,
clean and/or replace your
robot’s lter as needed.
Install a new bag, sliding the
plastic card into the guide rails.
Discard the used bag.
Press down on the lid making
sure that it is completely closed.
4
3
5
Note: This will seal the bag
so dust and debris cannot
escape.
Replacing the Bag
Pull up on the plastic card
to remove the bag from the
canister.
Lift up on the canister lid to
open.
1
2
Removing Debris from Blower Cover
Inspect blower cover for any lint or
debris build-up, and wipe with a
clean dry cloth to remove.
Inspect the visual docking target and
charging contacts to make sure that
they are clear of debris. Wipe with a
clean, dry cloth.
Cleaning the Visual Docking Target and Charging Contacts
Important: Do not spray
cleaning solution or water onto
the sensors or sensor openings.
To Next Page
Loading...
Need help?
General
