4. Set a function (MODE)
Press the ‘MODE’ key repeatedly until you have reached the desired function. You have a selection of the
following functions (the short text shown here in brackets appears at the top of the display):
- Time
- Daily step counter (STEP)
- Odometer (ODOSTEP) – for one training unit
- Distance covered (KM or MILE)
- Calories burned (KCAL)
- Time active – measurement of amount of time walked in minutes (MIN)
- Totalizer for all measurements (STEP TOTAL)
‘STEP TOTAL’ is followed by the first function ‘Time’.
As soon as you have reached the desired function, you can operate the device as described below.
Caution: If you do not press any key for more than 3 minutes or if the device is not moved, the device
automatically switches to a save-battery mode, i.e. the display is switched off. All functions continue to run in
the background. To reactivate the display, either move the device or press one of the keys.
4.1 The function time
Allows you to set the time and your personal details
You can also use the PE-DRO as a quartz watch. You can set the time and your personal details. To use
the additional possibilities of the PE-DRO, you have to enter your personal details. These data are then
used to calculate the following information:
- Distance
- Calories burned
- Graphic display of the steps taken compared with the target for the day (in 10% steps)
Please note:
- The correct time setting is important in order to be able to use the STEP function correctly (daily step
counter). At midnight, all data in function 4.2, 4.3-4.6 are automatically reset to zero.
- Some information (distance, kcal, target) requires the input of your personal details.
Setting
Press and hold the SET key in the time mode (approx. 4 seconds) until the ’24-hour’ display starts to flash.
You can change the setting with the MODE and RESET keys. With the SET key, you move to the next
setting.
Setting sequence (the element to be set flashes):
24/12-hour time display ---> hour setting ----> minute setting ---> unit of step length cm/inch (used for the
bodyweight kg or pounds) ---> step length in the set unit (30-213cm / 12-84 inch)---> your body weight (20-
220kg / 50-500LB)) ---> target number of steps per day (100-99000 steps can be set in increments of 100 or
1000)
After the last setting in the sequence, namely the target number of steps per day, the setting is completed by
pressing on the SET key and you go back to the time display.
Caution: In the setting mode, if no key is pressed for more than 10 seconds, the change that has been made
is accepted and the setting mode is exited automatically.