14
IRRITROL Decoder Systems
Place the strain reliefs over the wires and secure
using the included screws and a TX10 screwdriver.
D. Setting a WIFI access point
Upon first startup the SSID of a WIFI access point
must be specified.
From a WIFI enabled device, connect to the 50-WIFI
interface SSID using password specified on the
product. You may optionally scan the QR code with
a suitable reader App.
Depending on your device and device settings you
are either,
a) shown the product web page. Simply start
usage.
b) asked to ‘sign in to network’. Press OK to show
the product web page.
For the functional ground use a short wire of
largest practical cross section to ground. This
protects the device from electrical surges
resulting from e.g., lightning. It is not a safety
ground! Prepare as shown to the right. Use a PZ2
screwdriver to fasten.
To Next Page
Loading...
