Need help?Do you have a question about the ISC Pulley and is the answer not in the manual?
The primary connection point of the pulley for attachment.
The rotating component over which the rope passes.
Marking indicating the type of bearing or bushing used.
Indicates compliance with National Fire Protection Association standards.
Pulleys require inspection for damage to side frames and sheaves.
Sheaves must be inspected to ensure they rotate smoothly.
Pulley can be used inline with the direction of pull.
Pulley is suitable for use in redirecting a line.
Attachment of the pulley with both side frames is described.
Do not use ropes exceeding the maximum diameter stated on the pulley.
Avoid using wire cables with aluminum pulleys to prevent wear.
Do not use pulleys in negative rigging or with more than one rope per sheave.
Can be loaded with a karabiner in either or both attachment eyes.
Frames should be aligned when connected at all times.
The primary connection point of the pulley for attachment.
The rotating component over which the rope passes.
Marking indicating the type of bearing or bushing used.
Indicates compliance with National Fire Protection Association standards.
Pulleys require inspection for damage to side frames and sheaves.
Sheaves must be inspected to ensure they rotate smoothly.
Pulley can be used inline with the direction of pull.
Pulley is suitable for use in redirecting a line.
Attachment of the pulley with both side frames is described.
Do not use ropes exceeding the maximum diameter stated on the pulley.
Avoid using wire cables with aluminum pulleys to prevent wear.
Do not use pulleys in negative rigging or with more than one rope per sheave.
Can be loaded with a karabiner in either or both attachment eyes.
Frames should be aligned when connected at all times.
General| Brand | ISC |
|---|---|
| Model | Pulley |
| Category | Security Sensors |
| Language | English |
To Next Page