Need help?Do you have a question about the Island Umbrella Santorini II and is the answer not in the manual?
General| Canopy Shape | Octagonal |
|---|---|
| Frame Material | Aluminum |
| Tilt | Yes |
| Crank Lift | Yes |
| Base Included | No |
| Vent | Yes |
| Wind Vent | Yes |
| Umbrella Type | Market |
| Canopy Size | 10 ft |
| Color | Beige |
| Material | Polyester canopy, Aluminum frame |
| Rotation | 360 degrees |
| Canopy Color | Multiple options available |
Place the stand on level ground and fill it with water.
Secure the base pole onto the top of the fillable stand.
Fasten the base pole to the stand using bolts and washers with the Allen wrench.
Place the swivel cover around the base pole, ensuring correct side alignment.
Position the main umbrella onto the base pole, aligning locking holes.
Insert and tighten the threaded knob into the locking hole.
Learn the purpose of the three crank holes for tilting, rotation, and opening/closing.
Use the crank handle in the middle hole to extend the umbrella.
Utilize the main pole's position holes to set canopy angles.
Operate the crank handle in the top hole to tilt the umbrella canopy.
Use the crank handle in the bottom hole to rotate the umbrella.
Turn the crank handle counter-clockwise to retract and close the umbrella.
Place the umbrella cover over the unit for storage or protection.
To Next Page