values of gain may make the residual noise more apparent, so you
will want to set this to a higher value on those presets.
E) INTELLIGENT SPEAKER(TM) Function
1. INTELLIGENT SPKR(TM) (OFF or ON): This turns on the speaker
filter function. It achieves virtually identical sound to a microphone
on a speaker cabinet, since it convolves the signal with actual
samples of a microphone on a speaker cabinet! This function
always affects the signal output on the Direct and Headphone
outputs, but will also affect the Stage Outputs if the Global
parameter ‘STAGE SPKR SIM’ is set to ON. This parameter is
useful if you want to use the Stage Outputs to drive a full-range
speaker such as a vocal wedge or even in-ear monitors, and use
the STAGE OUT LEVEL control to vary the level independently
from the DIRECT OUT signal, which typically feeds the front of
house system in a live situation, or mixer/DAW inputs in a recording
situation.
2. Type (4x10 Modern, 2x12 Modern, 1x15 Aluminum, 4x10 59 B-
man, 1x15+4x10 Stack, 8x10 Classic, or Lowpass Filter): Of
these, only the Lowpass Filter is not based on measurement of an
actual speaker, but is simply a fourth order lowpass filter
approximation to a speaker.
3. REACTANCE (-3 to +9): Bass boost or cut level. This simulates
the bump in the bass that can occur with a tube amp interacting
with the LF impedance bump (the reactance) in a speaker. If
anything it allows you to adjust the bass further to your liking.
4. MIC POSITION (-6 to +6): This simulates moving the microphone
from the edge of the cone to the center of the cone by appling a
high frequency shelf eq.
F) EXCITER Function.
1. EXCITER (OFF or ON): Turns it off or on. The exciter can also be
turned on or off by pressing the switch sequence 2nd, then MOD, if the
MOD SWITCH: function is set to EXCITER.
2. EXCITER MIX (0 to 100): Controls the amount of the effect.
3. EXCITER EQ (0 to 100): Varies the center frequency of the effect.
G) WAH Function.
1. WAH (OFF or ON): Turns the WAH on or off and selects if it is
placed pre or post distortion. There a 4 ways the WAH can be
turned on or off. One is by accessing this parameter and turning
the VALUE knob. The second is by pressing the 2
nd
switch (if it is
not already on), then pressing the MOD switch, if the MOD
SWITCH: function has been set to WAH. The third is to connect an
To Next Page
Loading...