ENGINE FUEL 6C-11
6.Disconnect air breather hose (3) and fuel filler hose (4) at
the fuel filler neck.
NOTE: Cover fuel hose to prevent any dust entering.
7.Remove the four fuel tank assembly fixing bolts at four
corners of the tank.
8.Let down the tank and disconnect the wiring connectors and
the emission hose at the emission port on the fuel pump
and sending assembly (5).
9.Remove fuel tank assembly along with protectors.
10.Remove roll over&float valve (1) along with the evaporative
fuel hose and pipe (2).
11.Remove fuel pump and sender assembly (5) by removing
the snap ring along with the fuel hoses (7, 8).
12.Remove tank protector by removing the fixing bolts.
Installation
1.Install protectors and tighten the fixing bolts to the specified
torque.
Torque; 68 N⋅m (6.9 kgf.m)
2.Install fuel pump and sender assembly by fitting in the snap
ring.
3.Install roll over&float valve (1).
4.Lift up fuel tank assembly and connect the emission hose to
the emission port and the wiring connectors on the fuel
pump and sending assembly (5).
5.Install fuel tank assembly along with protectors and tighten
the four fixing bolts to the specified torque.
Torque: 68 N⋅m (6.9 kgf.m)
6.Connect fuel filler hose (4) and air breather hose (3), and
clip them firmly.
7.Connect fuel delivery hose (7) and fuel return hose (8), and
clip them firmly.
8.Connect evaporative fuel hose (2).
9.Tighten fuel filler cap.
10.Connect battery ground cable.
Fuel Gage Unit
Removal and Installation
As for removal and installation of the Fuel Gauge Unit, refer to
"Fuel Tank" of this section 6C as the fuel gauge unit is
combined with the fuel pump and sender assembly.
To Next Page
Loading...
