DRIVEABILITY AND EMISSIONS 6E1-51
Getting Started
• Before operating the Isuzu PCMCIA card with the
Tech 2, the following steps must be performed:
1. The Isuzu 98 System PCMCIA card (1) inserts into
the Tech 2 (5)
2. Connect the SAE 16/19 adapter (3) to the DLC
cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Make sure the vehicle ignition is off.
5. Connect the Tech 2 SAE 16/19 adapter to the
vehicle DLC.
6. The vehicle ignition turns on.
7. Verify the Tech 2 power up display.
NOTE: The RS232 Loop back connector is only to use
for diagnosis of Tech 2 and refer to user guide of the
Tech 2.
Operating Procedure
The power up screen is displayed when you power up
the tester with the Isuzu systems PCMCIA card.
Follow the operating procedure below.
To Next Page
Loading...
