DRIVEABILITY AND EMISSIONS 6E1-127
Evaporative Emissions (EVAP) Canister Purge Valve Solenoid Check (Cont'd)
Step Action Value(s) Yes No
10
Probe each terminal of the solenoid valve electrical
connector with a test lamp to ground.
Does the test lamp light on both terminals?
-
Go to Step 11 Go to Step 12
11
Repair the short to voltage in the wire between the
solenoid and the ECM.
Is the action complete?
-
Verify repair
-
12 Does the ignition feed terminals light the test lamp? - Go to Step 13 Go to Step 14
13
Check for an open in the wire between the purge control
solenoid and the ECM.
Was there an open circuit?
-
Go to Step 15 Go to Step 6
14
Repair the open in the ignition feed wire.
Is the action complete?
-
Verify repair
-
15
Repair the open wire.
Is the action complete?
-
Verify repair
-