6E1-214 DRIVEABILITY AND EMISSIONS
• This malfunction detects a low impedance short to
ground or open contact on the purge control
solenoid output.
DTC (Flash DTC = 61)
Evaporative Emission (EVAP) Control System Canister Purge Control Valve Circuit Low
Error
Step Action Value(s) Yes No
1
Was the "On-Board Diagnostic (OBD) System Check"
performed?
- Go to Step 2
Go to OBD
System Check
2
1. Ignition ON, Engine OFF.
2. Using the Scan Tool, monitor info for Diagnostic
Trouble Code 61.
Does the Scan Tool indicate DTC 61.
-
Refer to
Diagnostic Aids Go to Step 3
3
1. Ignition OFF.
2. Disconnect the EVAP Canister Purge Control Solenoid
from the wiring harness connector from the EVAP
Canister Purge Control Solenoid.
3. Ignition ON, Engine OFF.
4. Using a Digital Voltmeter (DVM), check for voltage on
the "Engine IG." Fuse pin of the EVAP Canister Purge
Control Solenoid wiring harness connector.
Does the DVM read the following value? 12 Volts Go to Step 5 Go to Step 4
4
Check the suspect circuit between the EVAP Canister
Purge Control Solenoid connector and the "Engine IG."
Fuse for the following conditions:
• A short to ground
• An open circuit
• A short to voltage
Was the problem found?
-
Verify repair -
5
Using a DVM, check the resistance of the EVAP Canister
Purge Control Solenoid.
Does the DVM read the following value?
less
than 5
ohms Go to Step 6 Go to Step 7
6
Replace the EVAP Canister Purge Control Solenoid.
Verify repair.
- --
7 Replace the EPROM or ECM. Note) Refer to 6E1-243. - - -
To Next Page
Loading...
