DRIVEABILITY AND EMISSIONS 6E1-277
EMISSIONS
CATALYTIC CONVERTER
(IF APPLICABLE)
Refer to Engine Exhaust.
AIR CONDITIONING RELAY
Removal
1. Remove the fuse and relay box cover at right side of
engine room.
2. Refer to the diagram on the cover to determine which is
the correct relay.
3. Insert small screwdriver or use thumb pressure to
release the retainer of the relay.
4. Pull the relay straight up and out of the fuse and relay
box.
Installation
1. Insert the relay into the correct place in the fuse and relay
box with the catch slot aligned to retainer.
2. Press down until the catch of retainer engages.
3. Install fuse and relay box cover.
IGNITION TIMING ADJUSTMENT
There is no timing adjustment. The timing signal is furnished by
the CKP, ECM control the ignition timing.
EVAP CANISTER HOSES
(IF APPLICABLE)
To see the routing of the EVAP canister hoses, refer to
Emission Control System schematics.
To Next Page
Loading...
