ENGINE MECHANICAL (C22NE, 22LE, 20LE) 6A-33
Installation
1. Install toothed belt rear cover.
2. Install camshaft pulley while counterholding at camshaft
hex head.
3. Install camshaft housing cover.
Tighten (Torque)
Toothed belt rear cover to oil pump and camshaft housing - 6
N⋅m/4 lbf ft.
Camshaft housing cover to housing - 6 N⋅m (0.6 kgf⋅m).
Camshaft pulley to camshaft - 45 N⋅m (4.6 kgf⋅m).
4. Install toothed belt drive gear to crankshaft - 130 N⋅m
(13.3 kgf⋅m).
5. Install toothed belt according to the operation "Toothed
Belt".
Toothed Belt Tension Roller
Removal
1. Mark operating direction of toothed belt.
2. Remove toothed belt according to the operation "Toothed
Belt”.
3. Remove toothed belt tension roller (1) from oil pump.
Installation
1. Install toothed belt tension roller and make sure that the
locking lever (1) engages in the guide lugs (arrowed) on
the oil pump housing.
2. Install toothed belt according to the operation "Toothed
Belt" with paying attention to the operating direction of
toothed belt.
Tighten (Torque)
Toothed belt tension roller to oil pump - 25 N⋅m (2.5 kgf⋅m)
To Next Page
Loading...
